Remove the four 10mm bolts on the top of the grille using your socket. You can leave the clips holding it to the core support.Remove the three clips on either side holding the rubber radiator shroud in place on the grille shroud.You should be able to leave it attached on the outside as completely removing them isn't needed. Gently pull outward on the top of the headlight bezel and pop it free of the clips. Pop the headlight bezel free where it meets the center piece of the bumper.Remove the one clip on either side of the car holding the top of the headlight bezel in place.Pull out the remaining seven clips holding the upper grille/radiator cover in place and remove it from the car, you'll probably need to lift up the snorkel gently to pull it free.(tool holders not included) Part Number: CNCFRPTR-12PCUPGRD RAPTOR 12 TOOL UPGRADE by CNC FACTORY Raptor XPR 12 tool position carousal, rapid move rotary ATC servo carousal. Expand the Raptor holding capacity from 8 to 12 tool locations. Using your trim tool, remove the two clips holding the inlet snorkel in place Raptor XPR 12 tool position carousal, rapid move rotary ATC servo carousal.Under most conditions you have enough clearance to do this with the car on the ground, however having access to a lift can make some parts slightly easier.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |